KUMARAN. VLet’s imagine I’ve a steel sheet lower to a rectangle of 30 x 200 mm. To make the piece are compatible, I wish to drill 4x 4mm “holes” into the corners. (Assume fillets, however inverted.)
Do I wish to specify the middle level of the ones holes in a technical drawing, or does no longer specifying it point out that the centerpoint coincides with the 2 edges’ intersection level?
I want I may just add an image, however I will’t get that to paintings… I do know for fillets it’s not important to outline a place, however for my case I used to be no longer in a position to seek out an instance.
Edit:
u/Krzysd created an image for me: https://i.imgur.com/iLTvKb0.jpg
However then with an 8mm hollow by chance.
Is that this regarded as the “proper” method or are the centrelines pointless? (Retaining tolerances and many others out of scope at the moment)